Dear Anyone,
Who have seen this?
[ATTACH=CONFIG]248[/ATTACH]
Please tell me how to resolve it? Can I use XEM6006 FrontPanelHDL instead?
Thanks a lot
opal complaint.jpg (95.5 KB)
You should not add the NGC files to your project. Just place them in your working directory.
The design doesn’t work with the attached .ngc-files. If you add them you get an error message because the target fpga is a different one if you don’t, you get following massage:
ERROR:NgdBuild:604 - logical block ‘ep00’ with type ‘okWireIn’ could not be
resolved. A pin name misspelling can cause this, a missing edif or ngc file,
case mismatch between the block name and the edif or ngc file name, or the
misspelling of a type name. Symbol ‘okWireIn’ is not supported in target
‘spartan6’.