LabView to configure PLL on XEM3001

Spartan-3 USB 2.0 Modules
1

I am trying to configure the PLL on the XEM3001 from LabView but I am not getting very far. Can anyone offer suggestions or a sample VI that will configure the PLL?

2

Hello,
try with this labview project.
I extrapolated it from one of my VI’s.
It is quite simple to go into the code but if you have any problem let me know.

Ciao

Franceco

ok_pll_example.zip (712 Bytes)

3

Hi Franceco,

I can’t unzip your file… it’s says the archive is not valid. Could you try to post it again?

Thanks,
Craig

4

Hi Craig,
I tried and the .zip file is ok.
Send me a PM with your email and I will send it to you.
Please note that I made my own LV palette. It is mainly the one provided by OpalKelly but with some improvements to support firmware 3.0.

Regards

F.

5

Hello,

Can you please send me the LabVIEW code. You zip file only contains the project and no vi.
Thanks

[QUOTE=fradep;2717]Hi Craig,
I tried and the .zip file is ok.
Send me a PM with your email and I will send it to you.
Please note that I made my own LV palette. It is mainly the one provided by OpalKelly but with some improvements to support firmware 3.0.

Regards

F.[/QUOTE]

6

[QUOTE=akbar2852;4213]Hello,

Can you please send me the LabVIEW code. You zip file only contains the project and no vi.
Thanks[/QUOTE]

I am very sorry but I changed PC and I don;t have it anymore.

F.