Adding configuration flash to XEM3001?

Spartan-3 USB 2.0 Modules
1

I’m planning on using an XEM3001 in a standalone device, and need
to be able to boot configuration without a PC attached. Are the
FPGA configuration pins available? Or can it be done through the
Cypress processor? If this isn’t possible at all then I guess I’ll have
a couple of new XEM3001’s for sale :-(.

– Ralph

2

No, the XEM3001 must be configured via USB. After configuration, it can be detached as long as it is powered. The XEM3005 and XEM3010 boards can be automatically configured on boot.