Front Panel .bit configuration

Just received a new XEM 6001. I have set the switch for usb configuration and installed the driver under windows 7 64 bit. THe device is listed by front panel but the message after configuration with the prebuilt .bit files is " FPGA Configuration failed: File Error.

I have tehn tried the flash loader example with cmd and managed to program the counters example ones and never again.

What could be wrong? Or even better what am i doing wrong?

Looking forward to your reply.

Theodoros Athanasopoulos

What bitfile are you using and where are you getting it from?

— Begin quote from Opal Kelly Support;4032

What bitfile are you using and where are you getting it from?

— End quote

I am using the counters.bit that came with xem6001 cdrom. It is the correct file for the board since i can program it into rhe onboard eprom.