Feedback:
In general your products are great (I am using XEM3010 and FrontPannel C++/Linux drivers). The board is small and elegant and the USB link abstraction is very intuitive and easy to use.
Suggestions (in random order):
-
Add support to program the on board FPGA config prom from the USB link.
-
Add prototyping area on the BRK3010 board.
-
Provide symbol and foot print of the XEM3010 for Cadsoft Eagle
-
Add header/jumper for powering the XEM from the USB bus.
-
Provide +VDC and 3.3V on BRK3010 JP2 an/or JP4. (these two headers are more useful than JP1, JP3 since a small rectangual breadboard or PCB can be mounted on them, providing application specific glue electronic.
-
Sell pre cut plastic enclosures that can hold XEM3010 and BRK3010.
-
Support host independent continious ti_clock.
Thanks for listening.
Kam